Turbo Oil & Coolant Lines
Is coolant seeping from the line at the turbo, or has the rubber section become brittle and cracked? In this category we bring together feed and return lines that carry coolant to and from the turbo, for you who need to replace a leaking or worn line on a turbocharged engine.
What do the turbo coolant lines do?
On water-cooled turbos, coolant flows into the bearing housing through a feed line and back to the cooling system through a return line. This can help keep temperatures down so the oil around the bearings does not boil and form coke, especially when the engine is switched off hot. A leaking or clogged line can therefore cause the turbo to overheat and, over time, bearing wear. The lines belong to the same system as the turbo itself and the other turbo parts.
How to choose the right line
- Function: Feed and return lines typically have different shapes and connections and cannot be swapped.
- Side: On twin-turbo engines there may be separate lines for each side, e.g. the Gates line for the Ford F-Series V6 3.5L, which is specified as right side.
- Material: The lines are available in aluminium, steel and steel with a rubber section. Which is relevant depends on the original design of your engine.
- Car and engine: The lines are shaped for specific engines, e.g. Gates lines for the BMW 328i 2.0L, Mini Cooper 2.0L and Volkswagen Tiguan 2.0L. Always check the part number against your car.
Installation and maintenance
Check whether gaskets and washers are included, and replace them together with the line. Tighten to the manufacturer's torque and bleed the cooling system afterwards so no air pockets remain at the turbo. Regularly check for coolant residue, cracks in the rubber section and corrosion at the joints. You can find more parts for the system under superchargers and turbos.
Frequently asked questions
What is the difference between a turbo feed line and a return line?
The feed line carries coolant from the engine's cooling system into the turbo's bearing housing, while the return line carries the heated coolant back. They typically have different shapes and connections and cannot be swapped.
How do I spot a faulty turbo coolant line?
Typical signs are coolant residue or a sweet smell at the turbo, a dropping level in the expansion tank and visible cracks in the rubber section. A clogged line does not always show visible signs, but can contribute to the turbo overheating.
Does the cooling system need bleeding after fitting a new line?
Yes, it is typically necessary. Air pockets can collect high up at the turbo and restrict circulation. Follow your car's bleeding procedure, warm up the engine, and check the level and for leaks again once the engine has cooled down.