0

Axle Shafts

Broken splines, worn U-joints or a new differential on its way into the axle? This category contains axle shafts, axle shaft kits and differentials listed by spline count and shaft diameter. It is for you if you are repairing an off-roader or strengthening the front or rear axle for a demanding project.

What the axle shaft does in the front and rear axle

The axle shaft transfers power from the differential to the wheel hub. At one end, the splines engage the differential's side gears. On a solid front axle there is typically a U-joint so the wheel can steer. In this category you will find, for example, complete axle shaft kits from OMIX for Dana 25/27 on the Willys and for Dana 44 front axles on the Wrangler 07-18. There is also a chromoly front axle shaft kit with U-joints for the Jeep Wrangler JK from Revolution Gear & Axle. You will also find Eaton differentials such as the Detroit Truetrac, listed by spline count and shaft diameter.

How to choose axle shafts

Start with the axle type and build your choice around it:

  • Axle type and position: e.g. Dana 30, Dana 44, 8.5 inch, 9 inch or AMC 20. Also choose between front and rear axle and between the left and right side.
  • Spline count and diameter: these must match the differential's side gears, e.g. 30 splines and 1.31 inches in a Dana 44.
  • Material and load: larger tyres, lower gearing and a differential locker increase the load on the axle. A stronger shaft can therefore be relevant, but the need depends on how you drive.
  • The rest of the driveline: if you are also changing the ring and pinion, the ratio must be within the range the differential is specified for.

Installation and inspection

Check bearings, seals and U-joints while the shaft is out anyway. A leaking seal can let gear oil run out towards the brakes. If you change the differential, the backlash typically needs to be set again. An installation kit with bearings and shims can help here.

Frequently asked questions

Does the spline count on the axle shaft have to match the differential?

Yes. Spline count and diameter must match the side gears in the differential, which is why the Eaton differentials are listed with both measurements. If you want to use shafts with more splines, you typically need a differential or side gears for that exact spline count.

When does it make sense to switch to chromoly axle shafts?

Larger tyres, low gearing or a locker increase the load on the axle. In those cases, stronger shafts can reduce the risk of breakage. The need depends on the axle type, how you drive and the rest of the driveline.

What should I replace at the same time as an axle shaft?

It is typically a good idea to check wheel bearings, seals and U-joints while the shaft is out. Worn parts can cause play, noise or gear oil leaks. How much you should replace depends on their condition.

View as Grid List
Sort by
Display per page