Electric Water Pumps
Want to control the coolant independently of engine speed? An electric water pump is driven by an electric motor instead of the belt and can pump on demand, depending on the control setup even after the engine is switched off. We have pumps for replacing original parts and for projects with modified cooling.
What does an electric water pump do?
The pump circulates coolant through the engine, radiator and, where fitted, the intercooler or heat exchanger. Because it is not driven by the belt, it places no mechanical load on the engine, and the flow can be regulated according to temperature instead of engine speed. This can give a more even temperature and less risk of overheating when the car is stationary after hard driving. Under water pumps you will also find belt-driven pumps if you want to compare solutions. In this category, power ranges from 10W to 58W, e.g. Bosch pumps with OE numbers such as 0005000386 and 15076931.
How to choose the right pump
- OE number: If the pump is to replace an original part, match the OE number exactly.
- Engine type: For conversions, there are pumps for specific engines, e.g. from Aeromotive for Ford Coyote, Chevrolet Big Block and Mopar Gen III HEMI 5.7L-6.7L, and from Ford Racing for Mustang Shelby GT500 07-12.
- Power and current draw: Higher power requires wiring, relay and fuse to be rated for it. The right pump depends on cooling demand, hose size and pressure loss in the system, not just on watts.
- Control: Consider whether the pump should run constantly or be controlled by a temperature controller.
Moroso and Gates are also brands in this category. If you keep the belt-driven pump, water pump rebuild kits may be relevant.
Frequently asked questions
Can I replace a belt-driven water pump with an electric one?
It is possible on many engines, but it depends on the pump's connections, space and control. It typically requires a modified belt routing, new wiring and a solution that regulates the pump according to coolant temperature.
What are typical signs of a faulty electric water pump?
Rising coolant temperature, cooling system fault codes or a pump that does not start can indicate a fault. The cause can also be the connector, fuse, relay or control unit, so check these before replacing the pump.
Does the cooling system need to be bled after installation?
Yes. Air in the system can cause local overheating and pump noise. The procedure depends on the car, and some cars require a bleeding procedure via diagnostic equipment. Follow the instructions for your car and the specific part number.