Nuts
Does your oil pan need new nuts, or does a thread need locking after an adjustment? In this category you will find nuts in imperial and metric sizes: flange nuts, jam nuts and adjusting nuts for rocker arm studs. The category is for you if you build, repair or maintain a project and need the right thread size.
What the different nuts do
A flange nut has a built-in washer that spreads the load over a larger area. If the flange is serrated, as on e.g. the Moroso M6 x 1.00 Serrated Zinc Flange Nut, it can also make it harder for the nut to work loose. A 12-point nut can be easier to get a tool on where space is tight. Jam nuts are low-profile nuts that are tightened against another part to lock a thread in a set position. From QA1 they are available with both right-hand and left-hand threads. You will find regular hex nuts under standard nuts.
How to choose the right nut
Start with the assembly, not the nut:
- Thread: Diameter and pitch must match the bolt or stud. Imperial sizes such as 5/16in-24 and metric such as M6 x 1.00 cannot be mixed.
- Thread direction: A nut with a left-hand thread only fits a part with a left-hand thread.
- Wrench size and height: Check the clearance for tools. With jam nuts, also check how much thread is available.
- Material and finish: Aluminium weighs less, while steel typically withstands a higher tightening torque. Black oxide and zinc plating protect differently against corrosion, and this depends on the environment.
Installation and maintenance
Follow the torque specification for the specific assembly. Oil pan nuts, for example, should be tightened evenly and in stages so the gasket is compressed uniformly. A washer under a nut without a flange can spread the load better. Special parts such as Moroso's stud girdle adjusting nut must be used with the parts specified for the part number. Check the thread every time you take the assembly apart, and replace nuts with damaged threads or flanges.
Frequently asked questions
How do I know whether I need a right-hand or left-hand thread?
The thread direction must match the part the nut will sit on. If the threaded rod or rod end has a left-hand thread, the jam nut must have one too. Check the direction before you order. A nut with the wrong thread direction cannot be screwed on.
How do I find the thread size of a bolt or stud?
Measure the outside diameter with a caliper and determine the pitch with a thread gauge. Imperial threads are given as threads per inch, e.g. 3/8-24. Metric threads are given as the distance in millimetres between thread crests, e.g. M6 x 1.00.
Can I reuse an old nut?
It depends on the type and condition of the nut. If the thread or flange is damaged, or the assembly has been exposed to heat and corrosion, you should replace the nut. Always follow the instructions for the specific assembly.