Fuel Injector Seals
Is there a smell of petrol around the injectors, or do new fuel injectors need to seal tightly in both the intake and the fuel rail? In this category we bring together O-rings, seals and injectors listed with precise O-ring sizes for you who maintain or upgrade your fuel system.
What do the fuel injector seals do?
Each fuel injector typically seals with an O-ring at the top against the fuel rail and an O-ring or seal at the bottom against the intake. A leak at the top can cause fuel leakage and a fire hazard, while a leaking lower seal can draw in unmetered air and cause a rough idle or a lean mixture. Over time the rubber can harden from heat and fuel, so it is common to replace the seals while the injectors are out anyway. You will find the rest of the system under fuel injection.
How to choose the right seal
Size and type must match both the injector and the way it is mounted:
- Top and bottom diameter: The product names state, for example, a 14 mm or 15 mm lower O-ring, an 11 mm top or two 8 mm O-rings at the bottom.
- Injector length and top hat: For injectors of, for example, 34 mm and 48 mm, the seal depends on whether a top hat is fitted; see also injector adapters.
- Fuel: Check that the material is intended for the fuel you run, e.g. ethanol blends.
- Changing injectors: If you fit different fuel injectors in your project, new O-rings may be needed if the dimensions change.
In this category you will find parts from, for example, Injector Dynamics, DeatschWerks and BLOX Racing. During installation, the O-rings are typically lightly lubricated and the injector is pressed straight in without twisting, so the rubber is not pinched or cut.
Frequently asked questions
Should I replace the O-rings when refitting the injectors?
It is typically recommended. Used O-rings can be hard, flattened or have small cuts from removal, and then they will not necessarily seal again. New seals reduce the risk of fuel leakage and unmetered air.
How do I find the right O-ring size for my injector?
Measure the diameter at the top and bottom of the injector, or check the injector's specification. Compare with the sizes in the product name, e.g. 14 mm or 15 mm, and see whether the injector uses a top hat or two smaller O-rings at the bottom.
What are the signs of a leaking injector seal?
Typical signs are a smell of petrol or moisture at the rail, rough idle, a lean mixture or fault codes for unmetered air. The symptoms can also have other causes, so check the seals before you replace injectors or other parts.