Throttle Pedals
Is your car responding to the throttle with a delay, unevenly or not at all? Then the fault may be in the pedal or its position sensor. We stock throttle pedals with a built-in sensor and separate pedal sensors for cars with electronic throttle control.
What does a throttle pedal with sensor do?
In cars with electronic throttle control, there is no cable between the pedal and the throttle body. Instead, a sensor measures the pedal position and sends the signal to the engine control unit. If the sensor is worn or faulty, this can typically cause uneven response, limp mode or fault codes.
How to choose the right part
First, find out whether your car has the sensor built into the pedal or mounted separately. Then choose based on:
- Car model and year – e.g. Volkswagen Passat 04-05, Volkswagen Jetta 11-15 or Ford Fiesta 11-19.
- Part number – compare with the original part, as connectors and brackets can vary within the same model.
- Symptoms – read out the fault codes before buying, so you know whether the problem is in the pedal, the wiring harness or the throttle body.
After installation, some cars may require the pedal position to be relearned or fault codes to be cleared. It depends on the car. The category includes parts from Hella. If you also want to change the surface of your pedals, check out our pedal covers or go to all pedals and pedal pads.
Frequently asked questions
How do I know if the pedal sensor is faulty?
Typical signs can be delayed or uneven response, limp mode and fault codes for pedal position. The same symptoms can also be caused by the wiring harness, connectors or the throttle body, so read out the fault codes before you replace the part.
Should I buy the complete pedal assembly or just the sensor?
It depends on the car. On some models the sensor is built into the pedal and replaced as a unit, on others it is mounted separately. Compare with your original part and the part number before you order.
Does the pedal need to be relearned after installation?
On some cars the engine control unit has to learn the pedal's end positions, or fault codes have to be cleared, before the car runs normally. The procedure depends on the car and engine control unit, so check the car's service manual or get help from a workshop.