Universal Bolts
What diameter, pitch and length is the bolt you want to replace? This category brings together titanium flange bolts and flange nuts with a hex head. They are for installations where no car-specific solution exists, and where low weight and a consistent look matter in your project.
Titanium flange bolts for general fitment
The bolts here are universal. In other words, they are not made for a specific joint but are chosen by dimensions. We stock them from Ticon in sizes from M6 to M12, and there is also an M8 flange nut. The flange under the head spreads the load over a larger area than a standard head, so you typically do not need a washer. For dedicated locations, you can also see our chassis and suspension bolts and engine bolts. You will find all variants under bolts.
How to choose the right universal bolt
Measure the bolt you need to replace and compare it with the product name. It is structured as diameter, length and pitch.
- Diameter: e.g. M6, M10 or M12.
- Pitch: M10 and M12 are available in both 1.25 and 1.5. The two cannot be used interchangeably.
- Length: from 15 to 25 mm. Make sure the thread gets enough engagement without bottoming out.
- Wrench size: 10, 14 or 17 mm depending on the size.
Titanium can gall against the thread. That is why it is typically recommended to use a suitable thread paste and to tighten to the torque that applies to the specific joint. If the bolt is fitted in aluminium, galvanic corrosion can occur depending on moisture and salt. If the joint requires a specific property class, you should first check that the bolt's specification meets it.
Frequently asked questions
How can I tell whether I need a 1.25 or 1.5 pitch?
Use a thread gauge on the old bolt, or compare it with a bolt whose pitch you know. On M10 and M12, the difference is small and hard to see with the naked eye. The wrong pitch can ruin the thread in the component.
How is the length of a flange bolt measured?
The length of flange bolts is typically measured from the underside of the flange to the tip of the bolt. So the head is not included. Measure your existing bolt the same way before choosing between e.g. 15, 20 and 25 mm.
Can a titanium bolt replace a steel bolt everywhere?
It depends on the joint. In many places, titanium can be used to save weight. Where the car manufacturer requires a specific property class or a single-use bolt, you should check that the specific part number meets the requirement before fitting it.