0

Cam Followers

The cam follower sits where the camshaft presses on the valve, and its dimensions must match your cylinder head precisely. We stock durable cam followers from Supertech, individually and in sets, for you who are rebuilding or upgrading the valvetrain in an engine project.

What the cam follower does in the valvetrain

The cam follower sits between the cam lobe and the valve and transfers the cam's motion to the valve. It is exposed to constant friction, and a worn or uneven part can cause incorrect valve clearance and noise from the cylinder head. The range includes, for example, cam followers from Supertech with DLC coating or WPC treatment, which are surface treatments typically intended to reduce friction and wear. If you are also working on camshafts or valve springs, the parts should be chosen so they match each other.

How to choose cam followers

  • Dimensions: The product names state three dimensions, e.g. 31 x 25.5 x 3.28 mm. Compare all dimensions with your engine's specifications, not just the diameter.
  • Adjustment: Some variants are used with 8 mm shims, others with lash caps, e.g. 5.5 mm for a Miata variant. This depends on the design of the cylinder head.
  • Engine: Some items are made for specific engines, e.g. Nissan KA24DE DOHC and Suzuki Hayabusa GSXR 1300.
  • Quantity: You can choose single pieces or sets of e.g. 8 or 12 pcs.
  • Surface: Whether DLC or WPC is relevant depends on load, camshaft and the rest of the build.

Installation and valve clearance

New cam followers typically change the valve clearance, so it must be measured and adjusted after installation. If the cylinder head has to come apart anyway, it can make sense to check the valves and other parts in camshafts and valvetrain at the same time.

Frequently asked questions

Does the valve clearance need adjusting after replacing cam followers?

Yes, typically. New cam followers and any new shims or lash caps can change the clearance, so it should be measured and adjusted to the engine manufacturer's specifications before the engine is started.

What is the difference between DLC coating and WPC treatment?

Both are surface treatments typically intended to reduce friction and wear. DLC is a thin, hard carbon-based coating, while WPC is a treatment of the surface itself. What makes sense depends on the engine and the rest of the build.

Should I replace all cam followers at once?

It depends on wear and the project. With an upgrade or a new camshaft, the whole set is often replaced so all followers are in the same condition. Single pieces can be used if only a few are damaged, but check the others for wear.

View as Grid List
Sort by
Display per page