0

Piston Wrist Pins

Are you replacing pistons or raising boost pressure in your project? The wrist pin connects the piston to the connecting rod and has to carry the full load from combustion. We stock pins in various diameters, lengths and wall thicknesses from brands such as CP Pistons and JE Pistons.

How to choose a wrist pin

The pin must fit both the piston's pin bore and the small end of the connecting rod, so start with the dimensions of your pistons or your piston set. Dimensions are given in inches, e.g. 0.866 or 0.927 inch diameter and 2.250 or 2.500 inch length.

  • Diameter: must match the piston and connecting rod precisely.
  • Length: depends on the piston's width and retaining system.
  • Wall thickness: e.g. 0.150, 0.200 or 0.250 inch. A thicker wall can increase stiffness but typically adds weight, so the choice depends on power goals, RPM and piston design.
  • Material and finish: e.g. 9310 steel, chamfered ends and DLC coating, which can reduce friction and wear.

Upgrading, installation and retention

Some pins are sold as an upgrade for a specific piston or engine, e.g. the CP pin for the Audi/VW 2.0L TFSI. Always check the part number against your piston before ordering. During installation, the pin should typically slide through the piston and connecting rod with the clearance specified by the piston manufacturer, so measure the clearance before assembling the engine. The pin is held in place by retainers, and you must use the type the piston is designed for, found among our piston clips. The category includes pins from brands such as CP Pistons, JE Pistons, Wiseco, Supertech and Mahle.

Frequently asked questions

Which wall thickness should I choose for my wrist pin?

It depends on power goals, RPM and piston design. A thicker wall can make the pin stiffer but typically increases weight. Follow the piston manufacturer's recommendation for your specific piston and project.

What is the difference between a wrist pin with and without DLC coating?

DLC is a hard, smooth surface coating that can reduce friction and wear between the pin, piston and connecting rod. Whether it is necessary depends on the load and on what the piston manufacturer recommends.

Can I reuse the old retainers when replacing the wrist pin?

This is typically not recommended, because retainers can lose tension when removed. Use new ones of the type the piston is designed for, and check that they are fully seated in the groove before assembling the engine.

View as Grid List
Sort by
Display per page

CP 2.250 Wrist Pin Upgrade

cpp905-2250-26CP3C
CP 2.250 Wrist Pin Upgrade
$458.29 excl. VAT