0

Gauge Mounts

Where should your new boost gauge go so you can read it without taking your eyes off the road for long? Gauge mounts give your 52 mm and 2-5/8" gauges a fixed place. You can choose single cups, brackets for free placement or dual panels for specific models.

Cups, brackets and panels for your gauges

A gauge cup encloses the gauge and is screwed in place, so you decide the position yourself. An aluminium bracket kit holds the gauge with a clamp, while a low-profile mount such as the Omni-Pod low profile mount gives a discreet placement. For some models there are dual panels, e.g. the AutoMeter panel for two 2-5/8" gauges in the Ford Mustang 1987-93. Angle rings can also tilt the gauge slightly towards the driver. If you would rather fit the gauge in a ready-made pod, see our gauge pods.

How to choose a gauge mount

  • Diameter: The mount must fit the gauge, typically 2-1/16" (52 mm) or 2-5/8". Measure the gauge housing before you order.
  • Placement: The gauge should be quick to read and must not block your view, obstruct the controls or sit in the way of airbags.
  • Number of gauges: One cup fits a single gauge. A dual panel is relevant when, for example, boost and oil pressure should sit side by side.
  • Finish: You can choose between e.g. black, silver, chrome and carbon fibre, so the mount matches the interior.
  • Installation: Check whether you need to drill into panels and whether there is room behind the mount for connectors and wiring.

Installation and adjustment

Fasten the mount to a stable surface so vibrations don't make the gauge hard to read. Route wires and any hoses away from heat and sharp edges. The category includes parts from AutoMeter and Turbosmart, among others. If you want to change the front of the gauge, you'll find bezel parts under gauge bezel accessories. The rest of the range is under gauge accessories.

Frequently asked questions

Is there a difference between a 52 mm and a 2-1/16" gauge mount?

No, not in practice. 2-1/16 inches equals roughly 52 mm, and both terms are used for the same gauge size. 2-5/8" is a larger size and requires a mount in exactly that size.

Can I fit a gauge cup without drilling into the car?

It depends on the mount and on where it is going. Cups and brackets are typically screwed in place, but sometimes existing holes or screws can be used. Read the installation instructions for the specific part number before you start.

Why is it worth angling the gauge towards the driver?

A gauge that points straight ahead can be hard to read from the driver's seat and can cause glare. With an angle ring or a swivelling mount, you can aim the dial towards your eyes so a quick glance is enough.

View as Grid List
Sort by
Display per page

2-1/16" CUP, CARBON FIBER

atm2121
Autometer Carbon Fiber 52mm Gauge Cup
$651.78 excl. VAT

2-1/16" ANGLE RINGS PACK OF 3

atm2234
Autometer or Autogage 2-1/16in Black Angle Rings -- 3 Pack
$213.44 excl. VAT

2-5/8" DUAL ULTRA-LITE MUSTANG GAUGE

atm50105
Autometer Mounting Solutions Gauge Mount Gauge Cage Dual 2-5/8in Silver 87-93 Ford Mustang
$924.68 excl. VAT