Merge Collectors
Are you building your own headers, or do you need to merge several primary tubes into a single outlet with as little pressure loss as possible? This category contains exhaust collectors and merge collectors in stainless steel, in 2-1 and 4-1 versions with various tube sizes, for those of you who weld or modify the exhaust in your own project.
What a collector does in the exhaust
A collector joins the primary tubes from the headers or exhaust manifold into one common pipe. Its design affects how the exhaust pulses meet and can therefore influence flow and where in the rev range the engine pulls best. However, the effect depends on the entire system, including tube lengths, diameters and engine setup. The category includes both 4-1 collectors and 2-1 collectors, e.g. the Stainless Works 2-Way Formed Collector. If two pipe runs need to be connected further back, H-pipes, X-pipes and merge pipes are an alternative.
How to choose the right collector
Start with your primary tubes and the rest of the exhaust:
- Number of inlets: Whether you need a 2-1 or a 4-1 depends on how many tubes need to be merged and how the system is built.
- Inlet size: Vibrant specifies the inlet as an inside dimension (slipover ID), which must match the outside diameter of the primary tube. See, for example, collectors from Vibrant.
- Outlet size: Outlets in the category range from, for example, 2 to 6 inches. A larger outlet does not automatically give more power. It must suit the engine, power goals and the rest of the exhaust.
- Wall thickness and space: Stainless Bros, for example, states a wall thickness of 1.65 mm, and a short collector such as the 2-3/8 Four-Way Short Merge Collector can be relevant where space is tight.
Installation and fitting
Collectors are typically designed to be welded to the primary tubes and outlet pipe, so installation normally requires welding equipment and experience with stainless steel. Tack the parts together and check angles and ground clearance to the underbody before final welding. The outlet can be continued with exhaust pipes and flanges or joined with clamps. Whether the finished exhaust can pass inspection depends on the car and the complete system.
Frequently asked questions
What is the difference between a 2-1 and a 4-1 collector?
A 2-1 collector joins two tubes into one, while a 4-1 collector merges four primary tubes. The choice depends on how many tubes need to be merged and how the rest of your exhaust system is built.
How do I find the right inlet size?
Measure the outside diameter of the primary tube. At Vibrant, for example, the inlet is specified as an inside dimension (slipover ID) that the primary tube must fit into. Check the dimensions for the specific part number before ordering.
Can I install a collector without welding?
It depends on the product, but collectors are typically designed to be welded to the primary tubes. In some setups the outlet can be connected with clamps, but the joint with the primary tubes itself normally requires welding.
Does a modified exhaust need approval for inspection?
It depends on the car and the complete system. Changes to the exhaust can affect noise and emissions, so check the requirements and any approval for the specific parts before the car is used on the road.