Carburetor Jets
Is your engine running too rich or too lean after changes to the intake or exhaust? Carburetor jets control how much fuel is metered, and with the right size you can fine-tune the mixture. This category is for you if you want to tune a carburetor to suit your project.
What do carburetor jets do?
The jet has a calibrated orifice that determines how much fuel the carburetor can draw from the float bowl, especially under higher load. A larger orifice typically gives a richer mixture, a smaller one a leaner mixture. The requirement can change when you modify the intake, exhaust or fuel, or when the engine runs at a different altitude.
How to choose the jet size
- Orifice diameter: the size is stated in inches, e.g. from .069in to .080in in the Edelbrock main jets and from .040in to .076in in the S&S Cycle Series 72 Super Gas main jets.
- Thread and type: the jet must fit your specific carburetor; for example, Edelbrock Standard Main Jets have a 1/4-32 thread.
- Quantity per pack: some jets are sold in pairs, others in 5-packs, which makes it easier to test several steps.
Change in small steps and evaluate the result with a spark plug reading, a lambda/AFR measurement or a session on a dyno. An incorrect mixture can cause poor response, and a mixture that is too lean can, in the worst case, contribute to overheating.
Installation and maintenance
The jets are typically unscrewed with a screwdriver once the float bowl has been drained or removed. Use a tool that fits the slot precisely, and never clean the orifice with wire, as this can alter the calibration. If gaskets or other parts are worn, a carburetor rebuild kit may be relevant at the same time.
Frequently asked questions
How much should I change the jet size at a time?
It depends on the carburetor and the modifications to the engine, but small steps of one or two sizes at a time typically make it easier to assess the effect. Test after each change before moving on.
Can I use jets from another brand in my carburetor?
Only if the thread, design and calibration match your specific carburetor. Check the information for the specific part number, such as thread size and series, before choosing a jet.
How can I tell if the mixture is too rich or too lean?
Black soot on the spark plugs can indicate a rich mixture, while whitish spark plugs or stumbling under acceleration can indicate a lean mixture. A lambda/AFR measurement typically gives a more precise picture than the spark plugs alone.