Wheel Accessories
Does your wheel's centre bore not match your car's hub, or does a beadlock wheel need a new ring? This category brings together hub centric rings and beadlock rings for you who fit aftermarket wheels or maintain wheels for motorsport and off-road driving.
How to choose hub centric rings
Hub centric rings fill the gap between the hub and the wheel's centre bore so the wheel can be centred while the wheel bolts or nuts are tightened. This can reduce the risk of vibrations, but the ring typically does not carry the car's weight – the bolted connection does. You need to know two measurements: the outer diameter (OD), which must match the wheel's centre bore, and the inner diameter (ID), which must match the hub. From Enkei, for example, there are rings with an OD of 72.6 or 73 mm and an ID from 56.1 to 70.1 mm, including plastic versions. Check both values before you order, and be aware that wheel spacers can change which size the ring needs to be.
Beadlock rings: wheel size, hole count and fitting
A beadlock ring is bolted onto the wheel and clamps the tyre bead so the tyre can be held in place at low tyre pressure. The ring must match the wheel's diameter, hole count and construction – for example, there are rings from Raceline in 14 inches with 20 holes and from Method Wheels for 17-inch forged wheels in several designs and colours. Make sure the ring is designed for your specific wheel model, tighten the bolts according to the manufacturer's instructions, and re-check them after driving. Whether beadlock may be used on the road depends on the product and the car, so check the approval for the specific part number. If you also need new valves, you'll find them under tyre valves.
Frequently asked questions
What happens if the hub centric ring is the wrong size?
If the ring is too large, the wheel cannot fit over the hub. If it is too small, the wheel can sit off-centre and cause vibrations. So measure both the hub diameter and the wheel's centre bore, and compare them with the OD and ID of the product.
Do I need new hub centric rings when I change wheels?
Typically yes, because the outer diameter must match the centre bore of the specific wheel. The rings can also wear or deform, so check them when changing tyres, and replace rings that are cracked or sit loosely.
Can I fit a beadlock ring myself?
That depends on the wheel and your experience. The bolts must be tightened evenly in a cross pattern to the torque specified by the manufacturer and re-checked after driving. If in doubt, let a tyre shop with experience in beadlock wheels do it.