Glow Plugs
Does your diesel need several attempts before it fires up on a frosty morning? Glow plugs heat the combustion chamber so the fuel ignites more easily during a cold start. This category contains glow plugs from NGK and AirDog for diesel engines and projects where reliable starting in cold weather counts.
What glow plugs do in a diesel engine
A diesel engine ignites the fuel using compression heat, and at low temperatures that heat can be insufficient. The glow plug is heated electrically before and during starting and, on many engines, also briefly afterwards. This can reduce smoke and rough idling in the first few minutes. If one or more plugs fail, it typically shows up as long cranking, white smoke or an engine that shakes until it is warm.
How to choose glow plugs
Glow plugs are engine-specific, so the starting point is the engine code or displacement and the system voltage. For example, we have plugs for the Chevrolet/GMC 6.6L Duramax, Ford 6.0L and 6.4L Powerstroke and Ford IDI 6.9L, all rated at 12V. Also check:
- Thread, length and tip design, which must match the cylinder head
- Whether the engine control unit requires a specific type for after-glow
- The part number, e.g. NGK Y-546J or Y-732J, against the vehicle's parts data
You will find parts from NGK and AirDog. If a petrol engine needs new spark plugs, they are under spark plugs, and the whole range is gathered under spark plugs and glow plugs.
Installation and replacement
The plugs can be seized by soot and corrosion, so loosen them carefully with the correct tools and follow the manufacturer's tightening torque. In the worst case, a broken plug can require removal of the cylinder head. A resistance measurement can show whether a plug is faulty before you replace it. If the engine still starts poorly with new plugs, the cause may lie in the relay, control unit or wiring.
Frequently asked questions
Should I replace all glow plugs at once?
It is not a requirement, but the plugs are typically the same age and worn evenly. Replacing them together saves you from having to remove the same parts again when the next plug fails.
How do I test whether a glow plug is faulty?
Measure the resistance between the plug's terminal and ground with a multimeter, and compare it with the value for the specific plug. An open circuit or a markedly deviating value typically indicates a faulty plug.
Can I use glow plugs from another engine if the thread fits?
This is not recommended. Length, tip, voltage and heating profile depend on the engine, and the wrong plug can cause poor starting or, in the worst case, hit the piston or pre-chamber. Use the part number for your engine.