Temperature Sensors
Is your temperature gauge stuck, or is the engine management getting incorrect signals about coolant or intake air? This category contains sensors that measure temperature and pass it on to the engine management or gauge – for cars, Jeeps and motorcycles.
What does a temperature sensor do?
A temperature sensor converts the temperature of, for example, coolant or intake air into an electrical signal. The engine management can use the signal to adjust the mixture and ignition, and a faulty sensor can cause fault codes, hard cold starts or incorrect readings on the gauge. The category includes, for example, a coolant temperature sensor from OMIX for CJ and SJ models, an intake air temperature sensor from Hella and a sensor from TwinPower for H-D Touring, Softail and Dyna.
How to choose a temperature sensor
Start with what the sensor needs to measure, and then check:
- that the part number is listed for your model and year, e.g. 02-09 Nissan 350Z or 04-11 Jeep
- that the connector type and thread match
- that the signal and resistance curve match your engine management or gauge
For projects with standalone engine management, a universal pressure and temperature sensor from Bosch can measure both in one unit. If you only need to measure pressure, see pressure sensors, and for manifold pressure and boost pressure MAP sensors.
Frequently asked questions
How can I tell if a temperature sensor is faulty?
Typical signs are fault codes, a temperature gauge that is stuck or fluctuates, and hard cold starts. However, it can also be caused by wiring, connectors or the thermostat, so it is a good idea to test the sensor before you replace it.
Can I use a universal sensor instead of the original?
It depends on whether the sensor's signal and resistance curve match your engine management or gauge. A universal sensor typically requires that the system can be calibrated for it – otherwise you should choose a sensor that is listed for your model.
What should I watch out for when fitting a coolant temperature sensor?
Let the engine cool down before you open the cooling system, and be ready to catch the coolant. Use the seal specified for the product, and afterwards check for leaks and air in the system.
Bosch Universal Pressure and Temperature Sensor
Hella 02-09 Nissan 350Z Temperature Sensor - 6pt
Hella Intake Air Temperature Sensor - 6pt
Omix Coolant Temperature Sensor 72-86 CJ & SJ Models
Omix Intake Temperature Sensor 04-11 Jeep Models
- 1
- 2