0

Lifters

Is your cylinder head ticking at idle, or does your new camshaft require a different type of lifter? In this category we have collected hydraulic lifters – both roller lifters and flat tappet models – for a range of engine types, for you who are rebuilding or upgrading the valvetrain in a project.

Hydraulic roller lifter or flat tappet?

The lifter transfers the movement of the cam lobe on through the valvetrain, typically via a pushrod and rocker arm. A flat tappet slides directly on the cam lobe, while a roller lifter has a wheel that rolls on it. The two types typically each require their own cam profile, so the lifters must be chosen together with the camshaft. Hydraulic lifters automatically compensate for valve lash using the engine's oil pressure.

How to choose lifters

  • Engine: Lifters are engine-specific, e.g. Brian Crower for Chevrolet/GM Gen III/IV/V LS7, GSC Power Division Zero-Tick for Mitsubishi 4G63 and COMP Cams for Oldsmobile/Pontiac.
  • Diameter: The lifter must match the lifter bore in the block, e.g. 0.842 inch on several COMP Cams models.
  • Cam profile and RPM: How stable the valvetrain is at high RPM depends on the interaction between lifters, camshaft and valve springs.
  • Surface and quantity: Some flat tappet lifters have a DLC coating – a hard, friction-reducing surface – and lifters are available individually or in sets, e.g. sets of 16.

Installation and break-in

Check the length of the pushrods when changing lifters or camshaft, as incorrect geometry can cause wear and noise. Flat tappet lifters typically require a careful break-in and oil with suitable additives, while hydraulic lifters should be pre-lubricated according to the manufacturer's instructions. You can find the rest of the parts under camshafts and valvetrain.

Frequently asked questions

Can I reuse old lifters with a new camshaft?

With flat tappet lifters this is typically not recommended, because lifter and cam lobe wear in together. Roller lifters can in some cases be reused if the roller and body show no wear, but always follow the cam manufacturer's recommendation.

Can I switch from flat tappet to roller lifters?

It typically requires a camshaft with a roller profile and depends on the engine block. For some engines, retro-fit lifters are available, e.g. Edelbrock Evolution Retro-Fit for Chrysler 273-360. Also check the pushrod length after the switch.

Why do hydraulic lifters tick?

Ticking can be caused by low oil pressure, the wrong oil, air in the lifter, wear or incorrect preload on adjustable rocker arms. Find the cause before you replace parts – new lifters will not fix an oil problem.

View as Grid List
Sort by
Display per page

Lifter Set - M-6500-R302H

frpM-6500-R302H
Ford Racing High Performance Hydraulic Roller Lifter
$4,052.14 excl. VAT

DLC HYDRAULIC FLAT TAPPET

cca310103016
Comp Cams GM Applications Xtreme Energy DLC Hydraulic Flat Tappet Lifter .842in Dia. - 8 Cyl
$1,157.33 excl. VAT

DLC HYDRAULIC FLAT TAPPET

cca310113001
Comp Cams Oldsmobile/Pontiac Applications DLC Hydraulic Flat Tappet Lifter .842in Dia. - Single
$147.29 excl. VAT