Transmission Gaskets & Seals
If oil is seeping from the transmission pan or side cover, a worn-out gasket may be the cause. This category contains gaskets for automatic and manual transmissions – for you who need to change the oil and filter in an automatic transmission, rebuild the gearbox or seal it after a conversion in your project.
Where the transmission needs sealing
A transmission has several joints that must keep the oil in: oil pan, side cover, top cover, extension housing and the joint to the engine. The category includes, for example, a pan gasket for Ford E40D/4R100, an extension housing gasket for Toyota Pickup and 4Runner, a top cover gasket for manual transmissions from Omix and TwinPower gaskets that replace original H-D part numbers. If several gaskets need replacing at the same time, one of our complete transmission gasket kits can be an advantage.
How to choose a gasket
- Fit: transmission type, cover shape and number of bolts must match, e.g. the Fel-Pro pan gasket for Toyota Celica and Mazda Miata in the 14-bolt version.
- Construction: Moroso, for example, offers a reusable gasket for GM 4L80E and a 3/16 inch thick gasket of silicone molded on steel for GM Turbo 400. Which type seals best depends on the flange, cover and tightening.
- The mating surface: a bent oil pan or an uneven flange can cause leaks regardless of the gasket.
In addition to the brands mentioned, you will also find gaskets from Cometic Gasket and Pure Drivetrain Solutions.
Installation and maintenance
Clean the surfaces completely of old gasket material and oil, check that the flange is flat, and tighten the bolts in a crisscross pattern to the manufacturer's torque – overtightening can deform both the pan and the gasket. If you are changing the oil and filter in an automatic transmission, it is a natural time to renew the pan gasket. Leaks at the shafts are more often caused by oil seals than gaskets, while O-rings and transfer case gaskets each have their own category.
Frequently asked questions
Can a transmission pan gasket be reused?
It depends on the type. Some gaskets are made to be reusable, e.g. Moroso's reusable gasket for GM 4L80E, while many standard gaskets should be replaced every time the pan has been removed.
How can I tell whether the gasket or an oil seal is leaking?
Clean the area and take a short drive. If the oil trace runs along the edge of the cover, the gasket is likely; if the oil comes from a shaft or at the extension housing outlet, it may be an oil seal.
Should I use sealant with the gasket?
It depends on the gasket and the manufacturer's instructions. Some types must be installed dry, and too much sealant can push the gasket out or end up in the oil and clog passages or the filter screen.
Why is the transmission leaking shortly after a gasket replacement?
Typical causes are overtightened bolts, a bent oil pan, remains of old gasket on the surface or a gasket that does not fit your specific transmission type. Check the flange and tighten to the specified torque.