0

Cam Bearings

Are you building your engine up from the bare block, or are the old cam bearings showing wear and scoring? Cam bearings are thin bushings that are typically pressed into the block and support the camshaft on an oil film. We stock complete bearing sets from ACL, Clevite and King Engine Bearings.

What cam bearings do

The bearings keep the camshaft centred and feed engine oil to the shaft, so it runs on an oil film instead of metal against metal. Worn bearings can cause excessive bearing clearance, lower oil pressure and increased camshaft wear. During a rebuild, cam bearings are often replaced together with main bearings and rod bearings, since everything is taken apart anyway.

How to choose cam bearings

Always choose based on the specific engine, not just the displacement. In this category you will find, for example, sets for GM V8 from 4.3 to 6.6 litres, Ford Y-Block, Chrysler 318/360 and 383-440, as well as Cummins B-Series. Check in particular:

  • Engine code and model year, as bearing dimensions can change between generations of the same engine.
  • Number of bearings in the set – for example, the King set for Chevrolet 366-502 contains five bearings.
  • Oil hole position, so they line up with the oil passages in the block.
  • Outer and inner diameter, especially if the block has been machined.

Whether you choose ACL, Clevite or King Engine Bearings, always check the part number against your engine.

Installation and inspection

Cam bearings are typically pressed in with a dedicated installation tool, and each bearing must go in its own position, as the bearings in a set can have different dimensions. Clean the oil passages thoroughly before installation so debris does not score the bearing surface. Afterwards, check that the oil holes line up and that the camshaft turns freely when lubricated.

Frequently asked questions

Can I reuse the cam bearings during an engine rebuild?

It depends on wear and bearing clearance, but the bearings are typically replaced when the block has been stripped and cleaned. Scoring, uneven wear or exposed base metal are signs that the bearings should be replaced.

Why is it important that the oil holes line up?

The oil holes route oil from the block's passages to the bearing and on through the engine. If a bearing is rotated or in the wrong position, the oil supply can be restricted, which can lead to wear and low oil pressure.

Do cam bearings require special tools for installation?

Typically yes. The bearings are thin-walled and can easily deform if they are hammered in without a suitable installation tool. If you lack the tools or experience, an engine shop can press them in and check the fit.

View as Grid List
Sort by
Display per page

cleMS2328H

cleMS2328H
$1,763.99 excl. VAT