Exhaust Flanges
Need a tight joint between turbo, exhaust manifold and pipes? The flanges in this category are for you if you build or modify your own exhaust, and include V-band flanges, header flanges and turbine outlet flanges in stainless steel or aluminium.
What does an exhaust flange do?
A flange is the fixed connection point where two parts of the exhaust are clamped together, e.g. headers to the cylinder head, the turbo outlet to the downpipe or two sections of exhaust pipe. The flange is typically welded onto the pipe so the joint can be taken apart again for service or modification. V-band flanges consist of a male and a female half held together by a clamp, while header flanges and turbine outlet flanges are bolted in place.
How to choose the right flange
- Pipe diameter: V-band flanges are specified by the pipe's outside diameter, e.g. 3, 3.5 or 4 inches, so measure the outside of the pipe.
- Material: Stainless steel typically withstands high heat close to the engine and turbo. Aluminium weighs less, but whether it can be used depends on the temperature at the joint and on what the specific flange is designed for.
- Male or female half: A V-band joint requires both halves, so check whether you need one or two.
- Bolt pattern and inlet: For turbine and header flanges, dimensions and bolt holes must match the turbo or cylinder head. A flange from Stainless Bros, for example, is specified with a 4.625-inch inlet, four bolts and 4-inch pipe.
Installation and maintenance
The pipe should sit straight in the flange before welding so the joint can seal properly. Vibration and thermal expansion can stress the weld, and a flex section can relieve the system. Soot around the joint can indicate a leak, so retighten bolts or clamps after the first few drives. In this category you will find brands such as Vibrant, Stainless Works and Turbosmart, and more parts are available under exhaust pipes, flanges and turndowns.
Frequently asked questions
What is the difference between a V-band flange and a bolted flange?
A V-band joint is held together by a clamp around the male and female halves and can typically be taken apart quickly. A bolted flange is tightened with bolts and is used e.g. at the cylinder head and turbine outlet, where the bolt pattern has to match.
Should I choose stainless steel or aluminium?
It depends on where the flange will sit. Close to the turbo and exhaust manifold the temperature is high, and stainless steel is typically the safe choice there. Always check what the specific flange is designed for before choosing aluminium.
Can a modification with new flanges affect the vehicle inspection?
The flange is a connecting part, but the modification it is part of can affect noise, emissions and approval. It depends on the product and the car, so check the requirements for your specific project and the specific part number.