0

Wastegate Actuators

Is your boost pressure rising unevenly, or does it need to be set to a new level in your project? A wastegate actuator controls when the wastegate opens and routes exhaust gas around the turbine. We have pneumatic actuators with different spring pressures and electronic versions for you who want to control boost pressure precisely.

How the actuator controls boost pressure

The actuator is typically mounted on or near the turbo and connected to the wastegate flap by a rod. When boost pressure exceeds the spring pressure, the diaphragm is pushed and the flap opens, so part of the exhaust gas is routed around the turbine. The spring therefore determines the lowest boost pressure you can run, while a boost controller can typically raise it from there. If your project instead uses a separate valve in the exhaust, you will find it under wastegates.

How to choose the right actuator

  • Spring pressure: e.g. 14, 18 or 22 psi from TiAL Sport or 1.0 bar in Garrett's GT25 actuator. Choose based on the boost pressure your engine and management are tuned for.
  • Rod type: a straight or bent rod determines whether the geometry fits your wastegate arm.
  • Fitment: some actuators are made for specific turbos, while others may require brackets and adjustment. Check the bracket holes and the rod length.
  • Pneumatic or electronic: an electronic actuator such as Turbosmart's Straight Gate requires suitable control from the engine management or a separate unit.

In addition to Turbosmart, TiAL Sport, Garrett and HKS, we also carry Go Fast Bits. After installation, you should log boost pressure and check hoses and rod for leaks and play. If you need parts for the turbo itself, see turbo parts, and if the whole unit needs replacing, you will find turbochargers here.

Frequently asked questions

Which spring pressure should I choose?

Typically choose a spring pressure equal to or slightly below the boost pressure you want to run, so the controller has room to regulate. The right choice depends on the turbo, engine management and boost controller.

What is the difference between a straight and a bent rod?

The shape of the rod must match the angle between the actuator bracket and the wastegate arm. Incorrect geometry can cause uneven load, play or a flap that does not close fully. Measure your installation before you choose.

How do I adjust the preload after installation?

Preload is typically set by shortening or lengthening the rod so the flap is held closed with a little pressure. Too much or too little can change the opening pressure, so log boost pressure after adjusting.

View as Grid List
Sort by
Display per page

Forced Induction

gbe24401
Banks Power 99.5-03 Ford 7.3L Big Head Actuator Banks/Stock Housing
$1,968.26 excl. VAT

HKS Upgraded ACT Kit (R)PS13

hks1430-RN004
HKS Upgraded ACT Kit (R)PS13
$1,629.75 excl. VAT