0

Cylinder Head Stud Kits

Is your cylinder head lifting when boost or cylinder pressure rises? Head studs can provide more even clamping than standard head bolts and are designed for engines that need to handle more than factory specifications, e.g. in a turbo project or for track days.

What head studs do compared to head bolts

A head stud kit consists of threaded rods that screw into the engine block, along with washers and nuts. When tightening, the nut turns on the stud, so the stud is loaded mainly along its length and is not twisted like a bolt. This can give a more precise and even clamping force on the head gasket, which is relevant when higher pressure can lift the cylinder head. The threads in the block also typically wear less with repeated disassembly. For engines without those demands, a head bolt kit may be sufficient.

How to choose a head stud kit

Choose based on the engine: the kits are made for specific engines, e.g. Honda Civic L15B7 and Polaris RZR, where KraftWerks offers kits, or Toyota Supra B58 from Brian Crower. Also consider:

  • Material and tensile strength relative to power goals and cylinder pressure.
  • Length and thread that must fit the block and any machined cylinder head.
  • Torque and lubricant according to the manufacturer's instructions, not the factory values for head bolts.
  • Whether the head gasket should be replaced at the same time.

Installation and re-torquing

Installation requires removing the cylinder head, and the threaded holes in the block must be clean and undamaged. The studs are typically only threaded in lightly by hand before the nuts are tightened in several stages and in the manufacturer's sequence. Whether re-torquing is necessary depends on the kit and the head gasket. With the head off anyway, it may make sense to look at cylinder heads and related parts at the same time.

Frequently asked questions

Can head studs be reused?

It depends on the manufacturer and material. Some kits can be reused if the studs are not stretched or damaged, while others are recommended to be replaced. Follow the instructions for the specific part number, and measure the studs if the manufacturer specifies a limit.

Does the engine block need to be machined to install head studs?

Typically not, when the kit is made for your exact engine. With modified engines or cylinder heads with altered dimensions, however, length and clearance may differ, so check the measurements before you torque down.

Do head studs prevent the head gasket from blowing?

Not on their own. They can provide more stable clamping force, but a blown head gasket can also be caused by knock, overheating, excessive boost or uneven mating surfaces. Head studs should be seen as one part of an overall project.

View as Grid List
Sort by
Display per page

Cylinder Head Stud - M-6014-Z304

frpM-6014-Z304
Ford Racing Cylinder Head Stud Kit
$2,356.78 excl. VAT