0

King Pin Kits

Play in the steering, uneven tyre wear or a front wheel that wobbles can be caused by worn king pins. This category contains king pin kits and shim kits for ATVs and Willys and Jeep models from 1941-71, so you can restore tight and precise steering.

What does a king pin kit do?

The king pin is the pin that the steering knuckle pivots on when you steer. If the pin or bushings are worn, it can cause play, wandering and uneven tyre wear. A kit typically contains new pins and bushings or bearings, but the contents depend on the product. From OMIX, for example, there is a shim kit for king pin bearings on Willys and Jeep models from 1941-71, where shims can be used to adjust the bearing clearance.

How to choose the right kit

  • Match model and year with the product name, e.g. QuadBoss kits for Honda TRX200SX 86-88 or Kawasaki KLF220/250 Bayou.
  • Check whether the kit covers one or both sides.
  • Compare the contents with the parts you actually need to replace.

Installation and related parts

Play in the steering can also be caused by worn ball joints or tie rods, so check them while the front end is apart. Use grease according to the manufacturer's instructions, and have the wheel alignment checked after installation. More front-end parts can be found under steering components.

Frequently asked questions

How do I know if my king pins are worn?

Lift the front end and rock the wheel at the top and bottom. If you feel play that does not come from the wheel bearing or the tie rods, the king pins or bushings may be worn. Uneven tyre wear and a loose steering feel can also be signs.

What is a shim kit for king pin bearings used for?

Shims are thin washers that can be used to adjust the clearance in the king pin bearings during installation. The correct amount depends on the vehicle and the bearings, so follow the workshop manual or the manufacturer's instructions.

Does the wheel alignment need to be checked after replacing king pins?

It depends on the vehicle and on which parts have been taken apart. Work on the front end can affect the toe, so it is a good idea to have it checked to avoid uneven tyre wear and unstable steering.

View as Grid List
Sort by
Display per page