0

Pressure Senders

What oil pressure does your engine actually have under load? A pressure sender is mounted on the engine and passes the pressure on as an electrical signal to an electric pressure gauge. This category is for you if you are fitting a new gauge or replacing a faulty sender.

What does a pressure sender do?

The sender is typically screwed into a pressure port on the engine and changes its electrical resistance as the pressure changes. The gauge converts the resistance into a reading, so the sender and gauge must be designed for each other. One example in this category is a replacement oil pressure sender with a measuring range up to 100 PSI.

How to choose the right sender

  • Measuring range: must match the gauge – 100 PSI corresponds to approx. 6.9 bar.
  • Signal: the sender's resistance curve must match the gauge, otherwise the reading can be incorrect.
  • Thread: check the thread of the pressure port; you may need an adapter.

The category includes senders from AutoMeter; check the product description to see which gauges the specific sender is designed for.

Installation and troubleshooting

Many senders are grounded through the housing, so use thread sealant sparingly. Tighten carefully, and consider remote mounting with a hose if there are heavy vibrations, as these can shorten the sender's service life. If the reading fluctuates, the cause can be the sender, the wiring or a poor ground connection. You will find other types among our senders and sensors, and in the parent category you can compare with similar parts.

Frequently asked questions

Can I use the sender with a gauge from another brand?

That depends on whether the sender's resistance curve and measuring range match the gauge. With the wrong combination the reading can be misleading, so check the specifications of both sender and gauge before you install them.

Why does the oil pressure gauge read incorrectly after installation?

Typical causes are a poor ground connection, too much thread sealant, a loose wire or a sender and gauge that do not match. It can also be a genuine pressure problem, so it is a good idea to check with a mechanical gauge.

Does the sender have to sit directly in the engine block?

Not necessarily. Many mount it directly in the pressure port, but with heavy vibrations remote mounting with a hose and bracket can protect the sender. The sender may then require a separate ground wire.

View as Grid List
Sort by
Display per page