Vacuum Hoses
Is your idle hunting, or is the turbo not reaching the boost pressure it usually does? A cracked or collapsed vacuum hose may be the cause. Here we collect hoses for vacuum, emissions and washer fluid circuits – both sold by the metre and as complete kits for specific cars.
What vacuum hoses are used for
Vacuum hoses connect the intake to components such as the wastegate actuator, boost controller and emissions valves. If a hose becomes hard, cracks or collapses under vacuum, it can cause vacuum leaks, an unstable idle or fluctuating boost pressure. Hoses for washer fluid and emissions control look similar, but the requirements depend on what they are connected to.
How to choose a vacuum hose
- Inner diameter: The hose must fit tightly on the nipple. For example, 3 mm is available from Turbosmart and 5/32 inch from Gates.
- Reinforcement: The Turbosmart hose is reinforced, while the Gates hose is rated for 30 inHg vacuum and is not reinforced. A reinforced hose can typically hold its shape better under both vacuum and boost pressure.
- By the metre or complete kit: do88 offers kits for cars such as the Mazda MX-5 (ND), Audi S2/RS2/S4/S6 and Porsche 930 Turbo, saving you from measuring and fitting.
- Location and heat: Close to the turbo or exhaust manifold, the hose must withstand the temperature – check the product specifications.
FAST and Vibrant are also available in this category.
Installation and maintenance
Ideally replace all hoses in the same circuit at once, and secure the connections with clips where the nipple requires it. Regularly check for cracks at the ends. For larger connections on the intake and intercooler, silicone hoses are more relevant, and other types can be found under hoses, lines and tubing.
Frequently asked questions
When should I choose a reinforced vacuum hose?
A reinforced hose can typically hold its shape better when exposed to both vacuum and boost pressure, e.g. at the boost controller or wastegate. In pure low-pressure circuits, a non-reinforced hose may be sufficient, depending on the product specifications.
How do I find the right diameter?
Measure the outer diameter of the nipple or the inner diameter of the old hose. The hose should fit tightly without cracking when pushed on. Sizes are given in both millimetres and inches, so convert rather than guess.
Can a leaking vacuum hose cause fault codes?
Yes. Vacuum leaks and leaking emissions hoses can typically cause fault codes, a rough idle or an incorrect air-fuel ratio. Whether changes to the emissions circuit require approval depends on the product and car, so check this for the specific part number.