Ratchet Straps
Hauling tyres, tools or an engine on the trailer to your next track day? Self-retracting ratchet straps tension the load securely, and the loose end retracts into the housing so it doesn't flap around or get in the way.
How self-retracting ratchet straps work
A ratchet strap is tightened step by step using the handle, so the load can be held firmly without you having to pull hard by hand. On the self-retracting models, the strap sits on a reel inside the ratchet housing, and excess strap typically retracts when you release it. This means less loose strap on the truck bed and makes them easier to store in the car or on the trailer. Looking for straps without a ratchet? You'll find them under tie-down straps, and in the parent category tie-down straps, tow straps and ropes you can browse the whole range.
How to choose ratchet straps
The right choice depends on the load, the anchor points and how the strap needs to sit. Pay particular attention to:
- Width: From Rhino USA, the straps are available in e.g. 1 and 2 inch widths (approx. 25 and 50 mm). A wider strap spreads the pressure over a larger area, but the permitted load must always be read from the label.
- Permitted load: Check the marking for the specific part number – breaking strength and lashing capacity are not the same thing.
- Length: The straps are approx. 3 m (10 ft), so check that they reach around the load and to the anchor points.
- Quantity and colour: Choose between 2-packs and 4-packs; different colours make it easier to keep track of multiple sets.
Keep the ratchet free of sand and dirt, let the strap dry before retracting it, and discard straps with cuts, wear or damaged hooks. Ratchet straps are not designed for towing a car – for that you use tow straps, often together with shackles.
Frequently asked questions
How much can a ratchet strap hold?
It depends on the specific product. Check the label for the lashing capacity, and remember that the weight of the load, the number of straps and the lashing angle together determine whether the load is properly secured.
How do I prevent the strap from damaging the load?
Position the strap so it doesn't run over sharp edges, or use edge protectors. Only tighten until the load is secure – too much pressure can deform soft parts such as body panels or boxes.
Why won't the strap retract again?
It can be caused by dirt in the housing, a twisted strap or the ratchet not being fully released. Pull the strap out straight, clean the ratchet and let the strap dry before retracting it.