Parking Brake Cables
Does your handbrake pull to one side, or can you pull the lever all the way up without the vehicle holding still? Then a worn or rusty cable may be the cause. This category brings together parking brake cables from OMIX for Jeep and from QuadBoss for e.g. Honda, Suzuki and Yamaha.
What does the parking brake cable do?
The cable transfers the force from the lever or pedal to the brake at the wheel, so the parking brake can hold the vehicle still. Over time, the cable can stretch, rust solid in its sheath or develop broken strands. The brake can then drag, release unevenly or lose holding power. The cables belong to our parking and emergency brakes. If the brake still holds poorly after replacing the cable, it may be worth taking a look at the parking brake shoes.
How to choose the right cable
The cables are made for specific models and positions, so fitment decides your choice. In particular, check:
- Model and year: OMIX offers, for example, cables for Jeep Wrangler 87-89 and Jeep CJ models. QuadBoss offers rear parking brake cables for e.g. Honda TRX, Suzuki KingQuad and Yamaha Grizzly.
- Position: The product name states whether the cable sits at the front or rear, and whether it is for the left or right side.
- Version: Some cables come in special variants, e.g. for Yamaha Grizzly IRS. So compare with your vehicle's specification and with the old cable.
Installation and maintenance
Route the new cable the same way as the original and secure it in the brackets so it neither chafes nor gets pinched. Then adjust the brake so it releases fully with the lever down and holds when it is pulled. Check the cable regularly for rust, a cracked sheath and tension. Vehicles used in mud and water can typically require more frequent inspection. Whether the part is approved for road use depends on the product and vehicle, so check this for the specific part number.
Frequently asked questions
Should I replace both parking brake cables at once?
It is not always necessary. However, if one cable is rusty or stretched, the other is typically in the same condition. Replacing both also makes it easier to adjust the brake so it pulls evenly on both sides.
How can I tell whether the cable or the shoes are the problem?
If the lever can be pulled a long way without resistance, or the brake drags after release, it often points to the cable. If the brake holds poorly even though the cable is tight and moves freely, worn shoes may be the cause.
Can I adjust a stretched cable instead of replacing it?
A little stretch can often be adjusted out at the adjusting nut or at the lever. The cable should be replaced if the adjustment is used up, or if the cable is rusty, frayed or sticks in its sheath. An adjustment will not fix those faults.