Wastegates
Is your boost pressure rising more than you want, or does your turbo need to run higher boost in your project? A wastegate routes exhaust gas around the turbine, keeping boost pressure at the level you have chosen. This category is for you if you are building or upgrading a turbocharged engine.
How a wastegate works
The wastegate opens when boost pressure reaches the spring setting and sends part of the exhaust gas around the turbine, so the turbo does not spin any faster. It can be built into the turbo and controlled by one of our wastegate actuators, or it can be mounted separately on the exhaust manifold as an external wastegate. An external setup can typically give more precise control at higher power levels, but it requires space and a manifold with a flange for the valve.
How to choose a wastegate
The choice depends on several factors – size alone does not determine the result:
- Valve size: e.g. TiAL Sport MVS at 38 mm, Garrett GVW-40 and GVW-45, or TiAL Sport V50 and Garrett GVW-50 at 50 mm. The right size depends on the turbo, exhaust flow and power target, and a valve that is too small can struggle to keep boost down.
- Spring pressure: the spring determines the minimum boost pressure, e.g. 0.52, 1.0 or 1.3 bar. Typically choose a spring below your target boost if a boost controller is to raise it.
- Mounting: check the flange type, clamps and space around the manifold. Some variants come with clamps.
- Outlet: whether the gas is routed back into the exhaust or vented separately can affect both sound and roadworthiness inspection.
In addition to TiALSport and Garrett, you will also find Turbosmart, HKS and Granatelli Motor Sports in this category. For the rest of the turbo system, see our blow-off valves and turbo oil and water line kits.
Frequently asked questions
Which spring should I choose for my wastegate?
The spring sets the minimum boost pressure the wastegate can hold. Typically choose a spring slightly below your target boost if you want to raise the pressure with an electronic or manual boost controller. Without a controller, the engine runs at roughly the spring pressure.
Does an external wastegate require a new exhaust manifold?
It depends on the car. The manifold needs a flange and a pipe for the wastegate that match the valve size and flange type. If your current manifold does not have this, it will typically need to be modified or replaced.
Can my car pass inspection with a wastegate that vents to atmosphere?
It depends on the product and the car. A separate outlet can affect noise and exhaust emissions, so check the regulations and any approval for the specific part number before fitting it to a road-going car.