0

Valve Lash Caps

Is the rocker arm or cam follower wearing on the tip of the valve stem, or do you need to fine-tune the valve lash? A lash cap fits over the end of the valve stem, provides a hard contact point and can be used to adjust valve lash. This category is for you if you are building or rebuilding a cylinder head.

What does a lash cap do?

The cap sits over the end of the valve stem, where the rocker arm or cam follower pushes the valve open. It can protect the stem tip from wear and spread the load. How relevant this is depends on the valve material and the valvetrain. The thickness of the cap also affects valve lash, so it can be used for fine adjustment as well. Choose it together with the engine valves, valve springs and retainers, because the cap must clear the valve locks and retainer.

How to choose lash caps

  • Diameter: It must match the valve stem. For example, you will find caps from Supertech in 5.5 and 6 mm and from COMP Cams in 8 mm.
  • Depth: The depth indicates how far the cap goes down over the stem, e.g. 2.5 or 2.8 mm. Which depth you need depends on how much stem protrudes above the locks.
  • Thickness: Supertech is available in steps from 1.25 to 3.45 mm. This lets you hit the valve lash required by the camshaft specification.
  • Brand and material: In addition to Supertech and COMP Cams, we carry Ferrea. Check the material and dimensions for the specific part number.

Measure the valve lash after installation. Also check the caps during service, because wear or a cap that has shifted can change the lash. You will find the rest of the valvetrain under camshafts and valvetrain.

Frequently asked questions

How do I find the right lash cap thickness?

Measure the valve lash with a cap of known thickness and compare it with the camshaft specification. The difference shows how much thicker or thinner the cap needs to be. Always measure again after installation.

Can a lash cap hit the valve locks?

Yes, if the depth is wrong. The edge of the cap must clear the locks and retainer, otherwise it can sit crooked or damage the parts. So measure how much stem protrudes before you choose the depth.

Should lash caps be replaced during service?

It depends on wear and use. Inspect them whenever the valvetrain is apart. Wear marks, an uneven contact surface or a change in valve lash can be signs that the cap should be replaced. Use the same size unless the lash needs adjusting.

View as Grid List
Sort by
Display per page