0

Differential Rebuild Kits

Is your differential whining, leaking oil at the flange, or does it need to be taken apart and correctly reassembled? In this category we bring together bearings, oil seals, shim kits and thrust washers for rebuilding, e.g. for ATVs and UTVs from CFMOTO, Honda and Polaris.

What does a rebuild kit contain?

The kits cover the wear parts that are typically replaced when a differential is taken apart. From EPI, for example, there are bearing and seal kits for front and rear differentials on ATVs and UTVs from CFMOTO, Honda and Polaris. From ARB you will find, among other things, flange cover kits with bonded seal, shim kits and an H-type thrust washer kit. Cusco, OMIX and Eaton are also represented. This category belongs under differential and rear axle.

How to choose the right kit

  • Model and position: Kits are typically made for a specific model and for either the front or rear differential.
  • Dimensions: Shim kits are specified by dimensions, e.g. 82.5 x 70.0 mm, and must fit the specific bearing seat.
  • Part number: Check that the number in the product name, e.g. 123 or 166, matches your unit.
  • Scope: If the gears also need replacing, see ring and pinion and differential installation kits.

Installation and typical faults

Whine from the axle can be caused by worn bearings, but also by incorrect gear contact between pinion and ring gear – these are two different faults. Oil at the flange or axle typically points to a leaking oil seal. The result depends on correct bearing preload and backlash, which are adjusted with shims, and this requires measuring tools. Consider a new differential cover or a new gasket at the same time, and change the oil according to the manufacturer's instructions.

Frequently asked questions

When does it make sense to rebuild rather than replace the differential?

If the housing and gears are undamaged and the problem is caused by worn bearings or leaking oil seals, a rebuild can typically be enough. If the teeth are worn or broken, the ring and pinion must also be replaced.

Can I reuse the old shims?

That depends on whether the bearings or gears are replaced. New parts often change the dimensions needed for correct preload and backlash, so new shims in the right thicknesses may be necessary.

Can I install a bearing and seal kit myself?

Oil seals can often be replaced with ordinary tools. Bearings typically require a puller, press and dial indicator to set preload and backlash correctly. If you lack these, a workshop should do the job.

View as Grid List
Sort by
Display per page