Spark Plugs & Glow Plugs
Is your engine hard to start, does it misfire under boost, or does the ignition need to handle a more demanding project? This category brings together spark plugs for petrol engines and glow plugs for diesel engines. These are parts that affect cold starts, combustion and reliability, and that you typically replace as a full set.
Spark plugs and glow plugs – two different jobs
Spark plugs ignite the mixture in a petrol engine with a spark. Glow plugs heat the combustion chamber in a diesel engine so it starts more easily when cold. Worn spark plugs can cause misfires, a rough idle and higher fuel consumption. If you have misfires, it is also worth checking ignition leads and accessories, and you will find more parts under ignition and electrical.
How to choose spark plugs
Start with the dimensions that must match the engine: thread diameter, thread reach, seat type and hex size. After that, the choice depends on your project:
- Heat range: a colder spark plug transfers heat away faster and can reduce the risk of pre-ignition at higher boost or cylinder pressure. If it is too cold for the use, it can foul. HKS offers the M-Series, for example, in the standard heat range and one step colder.
- Electrode gap: with increased boost, a smaller gap may be necessary to avoid misfires. Follow the instructions for the specific spark plug, as some electrodes cannot tolerate being bent.
- Electrode material: iridium and platinum, e.g. NGK Single Platinum, typically wear more slowly than nickel, but the replacement interval depends on the engine and usage.
Installation and maintenance
Install spark plugs in a cold engine, thread them in by hand first, and tighten according to the manufacturer's instructions. Too tight can damage the thread, too loose can result in poor heat dissipation. Soot, oil or melted electrodes on the old spark plug are signs that the air-fuel ratio or heat range should be looked into more closely.
Frequently asked questions
Should I use a colder spark plug after tuning?
It depends on how much boost and cylinder pressure the engine sees. With heavy tuning, a colder heat range can reduce the risk of pre-ignition, but a spark plug that is too cold can foul with a lot of city driving.
Should spark plugs be replaced as a full set?
This is typically recommended so that all cylinders have the same electrode wear and a consistent spark. Several spark plugs in the category are sold in packs of e.g. 4 or 10, so you can replace them all at once.
How do I know if the glow plugs are faulty?
Typical signs are hard cold starts, rough running just after starting and smoke while the engine is cold. A glow plug can typically be tested with a multimeter, but the fault can also lie in the relay or the control unit.
Should the electrode gap be adjusted before installation?
It depends on the spark plug and the engine. Many come with a preset gap, but at higher boost a smaller gap may be necessary. Check with a feeler gauge and follow the instructions for the specific part number.