0

Carburetor Linkage

Does the throttle plate stick when you release the pedal, or does the engine run rich at part throttle? This category brings together rods, throttle levers, ball studs, choke brackets, kickdown parts and metering rods for the carburetor. It is for you if you want the throttle pedal and fuel metering to work precisely together in your project.

What do the throttle linkage and metering rods do?

The throttle linkage transfers the movement from the throttle pedal or throttle cable to the carburetor's throttle plate. Throttle levers, ball studs and rods should provide smooth movement without play and let the throttle plate open fully and close reliably. For automatic transmissions there are kickdown parts that connect the throttle movement to the transmission's downshift. Metering rods and secondary rods sit inside the carburetor and control – depending on the carburetor type – how much fuel is metered at part throttle. They work together with the carburetor jets, so the two parts should be assessed together.

How to choose throttle linkage parts

  • Carburetor type: Check that the throttle lever, bracket and rods fit your specific carburetor. If you are changing carburetor at the same time, you can find one among our carburetors.
  • Geometry and space: The choice depends on how the pedal and cable are mounted and on the space around the intake. If you raise the carburetor with a carburetor spacer, the angles can change, so an extension or a new bracket may become necessary.
  • Metering rods: Sizes are typically given in thousandths of an inch. A thinner rod typically gives a richer mixture, but the right combination depends on the engine, jets and springs.
  • Complete kits or individual parts: A complete throttle linkage kit from e.g. Edelbrock can be practical for a new setup, while individual parts from e.g. Edelbrock or Spectre cover replacement of worn components.

Installation and maintenance

After installation, check that the throttle plate opens fully at full pedal and closes by itself without sticking. Ball studs and joints can wear and develop play, so it is a good idea to check them when you are taking the carburetor apart anyway with a rebuild kit.

Frequently asked questions

How do I know if I should change metering rods?

If the engine runs too lean or too rich at part throttle, the metering rods can be part of the solution. Preferably change one thing at a time and assess the result with e.g. a wideband lambda gauge before you adjust jets or springs.

Why does the throttle plate not close fully after installation?

This is typically because the rod or cable is too tight, the bracket is misaligned or the return spring is too weak. Check the entire linkage with the engine off and make sure the throttle plate closes reliably before you drive.

Does the kickdown linkage need adjusting when I change carburetor?

Often, yes. If the throttle lever geometry changes, the kickdown function and shifting in the automatic transmission can be affected. The adjustment depends on the transmission and carburetor, so follow the instructions for the specific part number and check the shifts on a test drive.

View as Grid List
Sort by
Display per page

Throttle Bracket Pont 72-76

ede8014
Edelbrock Pont 72-76 Thro Brkt
317,58 € excl. VAT

Throttle Bracket SBC Vortec

ede8032
Edelbrock Universal Throttle Bracket
562,37 € excl. VAT

Throttle Bracket SBC/BBC

ede8031
Edelbrock Universal Throttle Bracket
614,73 € excl. VAT

THROTTLE LINKAGE

ede8011
Edelbrock A/T Rod Ext-Sb Ford
206,78 € excl. VAT

THROTTLE LINKAGE

ede9141
Edelbrock Chev Throttle Rod Stud
176,97 € excl. VAT