0

Cylinder Head Bolt Kits

Has the cylinder head been removed, and does it need to be torqued down again with the correct clamping force? This category contains complete head bolt kits for the cylinder head. They are for you if you are replacing the head gasket, rebuilding the engine or fitting a new cylinder head and want new bolts of the right length and strength.

Why head bolts often need replacing

The head bolts hold the cylinder head pressed against the engine block so the head gasket can seal against combustion pressure, coolant and oil. Many original bolts are torque-to-yield bolts that stretch slightly during tightening and are therefore typically only meant to be used once. Reusing them can result in too little or uneven clamping force and, in the worst case, a leaking gasket. The kits from e.g. Fel-Pro, Edelbrock and Ford Racing are designed for specific engines. One example is Edelbrock's kit for the Jeep 4.0L I-6.

How to choose the right head bolt kit

Start with the engine, not just the car model. Check the part number against the engine code and model year. Then look at:

  • Thread and length – some kits from S&S Cycle specify dimensions such as 7/16-20 and 2-3/8 inches.
  • Tightening method – torque, angle tightening and sequence depend on the engine and the bolt type.
  • Cylinder head and gasket – a different cylinder head or a thicker gasket may require different bolt lengths.
  • Bolts or studs – with higher boost pressure or frequent disassembly, head stud kits can be an alternative, depending on the engine.

Clean the threads in the block, use the lubricant specified by the manufacturer and follow the prescribed tightening sequence. If you need to replace the cylinder head itself, you will find it under cylinder heads.

Frequently asked questions

Can I reuse the old head bolts?

It depends on the bolt type. Torque-to-yield bolts are typically intended for a single installation because they stretch when tightened. Follow the engine manufacturer's instructions. If in doubt, fit a new kit together with the new head gasket.

What is the difference between head bolts and head studs?

Bolts are screwed directly into the block and tightened from the head. Studs are screwed into the block, and a nut is then tightened. This can give more consistent clamping force and protect the threads during repeated disassembly, but it depends on the engine and product.

Why is the tightening sequence important?

The cylinder head must be pulled down evenly against the block. If the bolts are tightened in the wrong order or with the wrong torque or angle, the head can sit unevenly and the gasket can start leaking. Use the values that apply to your engine.

View as Grid List
Sort by
Display per page

Head Bolt Set

felES729061
Fel-Pro Suzuki Forenza ES 72906-1 Engine Cylinder Head Bolt Set
490,48 € excl. VAT

Head Bolt Set

felES72834
Fel-Pro Audi A4 Quattro ES 72834 Engine Cylinder Head Bolt Set
1.213,70 € excl. VAT

Head Bolt Set

felES72909
Fel-Pro Kia Spectra ES 72909 Engine Cylinder Head Bolt Set
926,11 € excl. VAT

Head Bolt Set

felES72483
Fel-Pro Volkswagen EuroVan ES 72483 Engine Cylinder Head Bolt Set
1.026,33 € excl. VAT

Head Bolt Set

felES72185
Fel-Pro Toyota 4Runner ES 72185 Engine Cylinder Head Bolt Set
338,38 € excl. VAT

Head Bolt Set

felES74035
Fel-Pro Toyota Tundra ES 74035 Engine Cylinder Head Bolt Set
323,24 € excl. VAT