0

Cast Pistons

Have the cylinders in your Jeep or Willys engine been bored out, or does a worn engine need rebuilding with new pistons? Cast pistons in standard size and oversizes are designed for exactly this kind of overhaul of original engines.

What characterises cast pistons?

Cast pistons are typically made from an aluminium alloy and are often used in original engines where the load is close to factory level. This makes them relevant when you rebuild an engine without significantly increasing power. If you are planning a project with higher boost pressure or heavier loads, you can compare them with forged pistons. What suits you depends on the engine and your power target.

How to choose the right piston

The starting point is the engine and the model year. Here you will find, for example, pistons from OMIX for Jeep CJ and Wrangler with 2.5L, 4.0L and 4.2L engines, as well as for Willys and Jeep with the 134Ci engine. Keep the following in mind:

  • Oversize: sizes such as .010, .020, .030, .040 and .060 indicate how much larger than standard the piston is, and must match the cylinder bore after boring.
  • Clearance: have the bore measured so the gap between piston and cylinder wall matches the engine specification.
  • Model year: check that the year range in the product name covers your engine.

Other piston types can be found under pistons.

Frequently asked questions

What does .020 or .030 in the product name mean?

The number indicates the oversize relative to the standard bore, typically in inches. A .030 piston is used when the cylinder has been bored out by the same amount. The correct size depends on the measured bore after machining.

Can cast pistons be used in a tuned engine?

It depends on how much load the engine is under. For moderate tuning, cast pistons can be sufficient, but with higher boost pressure or harder use, forged pistons may be worth considering.

Should the piston rings be replaced at the same time as the pistons?

Typically yes. New pistons are normally fitted with new rings in the same oversize. Also check the cylinder wall and the ring end gap according to the engine specification before assembling the engine.

View as Grid List
Sort by
Display per page