Crimp Hose Ends
Do you prefer a crimped hose assembly over one you screw together? Crimp hose ends are fitted by squeezing a ferrule tightly around the hose with a crimping tool. This gives a compact, secure joint for fluid lines in your project, provided that the hose, end and tool are matched to each other.
How a crimp hose end works
A crimp end stays in place because the ferrule is pressed together around the hose. Other hose ends are screwed together instead. Once crimped, the assembly typically cannot be taken apart and reused, so measure the hose length and the position of the ends carefully before you crimp. Whether the joint stays leak-free depends on the hose, end and crimp dimension matching each other precisely.
How to choose the right crimp end
In this category you will find, for example, Russell Performance Proclassic crimp ends. Choose based on several factors at once:
- AN size: e.g. -4, -6, -8 or -10. The size must match both the hose and the fitting the end will be screwed onto.
- Outer diameter (O.D.): stated in the product name, e.g. 0.450 or 0.825. It must match the hose you are using.
- Angle: e.g. 45, 120, 150 or 180 degrees, depending on how the hose needs to be routed without kinks or sharp bends.
- Series: check that the end is designed for the exact hose type you are fitting it to.
You can find more parts from the same brand under Russell. If you need a different type of fitting, you can find it among our other hose ends and fittings.
Installation and inspection
Visually inspect the assembly after crimping, and pressure test the system for leaks before the car is put into use. Inspect hoses and ends regularly for wear, cracks and moisture around the ferrule.
Frequently asked questions
Can I fit crimp hose ends without special tools?
No, a crimp end typically requires a crimping tool with the correct dies for the specific size. If the crimp dimension is wrong, the joint can leak or come loose under pressure.
What does O.D. mean in the product name?
O.D. indicates the outer diameter the end is designed for, e.g. 0.600 on a -6 AN end. Measure your hose and choose an end where both the AN size and the outer diameter match.
Which angle should I choose for the hose end?
It depends on how the hose needs to be routed from the connection. Choose an angle so the hose does not kink, get stretched or bend sharply close to the end, and so there is clearance around other parts in the engine bay.