0

Bulkhead Fittings

Do you need to route a fuel, oil or coolant line through the firewall, the boot floor or a tank wall? Bulkhead fittings provide a secure, sealed pass-through, with the fitting locked into the panel by a nut. They are for you if you are building a project with AN hoses or a fuel cell.

What does a bulkhead fitting do?

A bulkhead fitting has threads on both sides of a collar and is clamped into a hole in the panel with a nut. This lets you connect the line on each side of the firewall, floor or tank wall without the hose chafing against a sharp edge. Besides fluid lines, there are electrical versions, e.g. the Electrical Bulkhead Stud Kit from Radium Engineering for power pass-through, and for fuel cells there are dedicated solutions such as the Russell Fuel Cell Bulkhead. Brands in the category include Fragola, Russell, Vibrant, Radium Engineering and Aeromotive.

How to choose a bulkhead fitting

  • Size: e.g. -3AN, -6AN or -8AN. The choice depends on the line's function and the flow the system requires.
  • Connection: AN connection on both sides or an adapter, e.g. 8AN male to 5/16 inch hose barb.
  • Angle: straight or 90 degrees depends on the space behind the panel and the hose routing.
  • Material and finish: steel or black anodised finish. Choose based on fluid, environment and appearance.
  • Thread length: must reach through the panel and leave room for the gasket and nut.

Installation and sealing

Drill the hole to the diameter specified by the manufacturer and deburr the edge. Depending on the fitting, sealing against the panel is typically done with a gasket or O-ring. On a fuel tank, a tight seal is especially important, so check the joint after the first drive. If you need other thread types, you will find them under NPT fittings and ORB fittings or in the overview of fittings and adapters.

Frequently asked questions

What is the difference between a bulkhead fitting and a regular AN fitting?

A bulkhead fitting is designed to be fixed in a panel with a nut so the line can be connected on both sides. A regular AN fitting joins a hose and a component but cannot be mounted through a bulkhead.

Can a bulkhead fitting be used on a fuel cell or tank?

Yes, if the fitting is designed for it. There are special bulkhead solutions for fuel cells. Check that the gasket and material suit the fuel type, and that the tank wall is flat and rigid enough for a tight seal.

Why does the pass-through leak?

Typical causes are burrs in the hole, an uneven panel, a damaged or incorrect gasket, or the nut being tightened too loosely or too hard. Also check that the hose fittings are tightened correctly on both sides.

View as Grid List
Sort by
Display per page

6AN BLKHD JAM NUT

rad14-0272
Radium Engineering 6AN Bulkhead With Jam Nut
146,08 € excl. VAT

FITTING

rad14-0670
Radium Engineering 6AN ORB w/ 10mm Barb to 6AN Male Bulkhead Fitting
181,84 € excl. VAT