0

Quick Connect Fittings

Does your new fuel system with AN hoses not fit your car's factory quick connect lines? Quick connect fittings are adapters that join the two systems, typically 5/16 or 3/8 inch EFI connections to AN or ORB threads. They are for you if you are upgrading the fuel pump, filter or lines in your project.

What does a quick connect fitting do?

A quick connect fitting joins a smooth tube end with a quick-release coupling, typically locked by a clip or spring, so the connection can be separated without loosening any threads. In this category you will find, for example, DeatschWerks adapters from 6AN male to 5/16 or 3/8 inch EFI female, a 90 degree Vibrant fitting from -8AN to quick connect with hose barb, and a Snow Performance fitting with 1/8 NPT thread. The brands Torque Solution and Radium Engineering are also represented.

How to choose the right adapter

Start with both ends of the connection, and check them for the specific part number:

  • Tube diameter: 5/16 and 3/8 inch EFI connections are not interchangeable.
  • Male or female: If the line has a smooth tube end, you need a female coupling, and vice versa.
  • Thread at the other end: AN fittings, ORB fittings and NPT threads each seal in their own way.
  • Angle and space: A 90 degree version can save space and avoid sharp hose bends.

Need a different transition? Browse the entire parent category fittings and adapters.

Installation and maintenance

The fuel system can be under pressure, so relieve the pressure before disconnecting a coupling. Check O-rings and locking clips, push the coupling fully on, and pull on it lightly to make sure it is locked. After start-up, you should check all joints for leaks. Whether a fitting tolerates, for example, ethanol-blended fuel depends on the product and must be checked.

Frequently asked questions

How do I know if my car has 5/16 or 3/8 inch fuel lines?

Measure the outside diameter of the tube with a caliper: 5/16 inch corresponds to approx. 7.9 mm and 3/8 inch to approx. 9.5 mm. Measure both the feed and the return, as they can be different sizes.

Can a quick connect fitting be reused after removal?

It depends on the coupling. Check O-rings and locking clips for damage or deformation, and replace them if in doubt. A damaged O-ring can cause fuel seepage even if the coupling clicks correctly into place.

Why does the connection leak at the thread and not at the quick connect?

Typically because the thread type or seal does not match: ORB requires an intact O-ring, AN seals on the flare, and NPT needs thread sealant. If the types are mixed or tightened incorrectly, leaks can occur.

View as Grid List
Sort by
Display per page

Coupler - SNO-82082R

snoSNO-82082R
Snow Performance 1/8NPT-1/4 Quick Connect Fitting
$123.86 excl. VAT

Lines & Fittings

dwk6-02-0121
DeatschWerks 6AN Male 5/16IN Female EFI Quick Connect Adapter
$226.70 excl. VAT

Lines & Fittings

dwk6-02-0103
DeatschWerks 6AN Male 3/8in Female EFI Quick Connect Adapter
$280.33 excl. VAT

NONEXTRUDEDALFITTING

vib16877
Vibrant 90 Degree Aluminum AN to Male Quick Connect Fitting -8AN - 0.375in Barb Size
$234.67 excl. VAT